Modified atmosphere packaging is typed two ways: by how the atmosphere is established, a pack is active or passive; by what the atmosphere contains, it is high-oxygen, low-oxygen, carbon-dioxide-rich or nitrogen-only. A packaging line has to answer both.
A pack whose air is drawn out and never replaced is vacuum packaging; an atmosphere held to a set point by continuous adjustment is controlled atmosphere storage, a bulk-room technique. A modified atmosphere is set once, at the seal.
MAP splits first by how the atmosphere gets established. In active MAP a machine replaces the air at the moment of packing, or an insert inside the pack changes the atmosphere after sealing. In passive MAP the product’s own respiration and the film’s permeability get there over days.
Passive MAP needs a respiring product and a film whose gas transmission matches that respiration rate.
EMAP is the engineered version of a passive pack — film area, thickness and permeability chosen against a measured respiration rate instead of by trial and error.
A machine replaces the air in one of two ways. Continuous gas flushing pushes a stream of gas through the pack while it is being formed and sealed, diluting the air out. Compensated vacuum evacuates the pack first, then backfills the gas mixture before sealing.
Gas-flushed packs hold up to 2–5% oxygen, which rules the method out for oxygen-sensitive products, and a vacuum step gets underneath that.
In practice the choice is made by the machine already on the floor, not by the product specification.
The third group of active MAP works after the pack is sealed: oxygen scavenger sachets, carbon-dioxide and ethanol emitters, ethylene scavengers, desiccants and one-way degassing valves.
These sit on top of a gas flush; they do not replace it.
Four gas mixtures cover most of what runs commercially: high-oxygen, low-oxygen, carbon-dioxide-rich and nitrogen-only.
| Atmosphere type | Typical mixture | Products | What the mixture is doing |
|---|---|---|---|
| High-oxygen | 70–80% O2, with at least 20% CO2 | Red meat | Oxygen keeps the myoglobin bloomed red; the CO2 share holds back the aerobic spoilage bacteria that oxygen would otherwise feed |
| Low-oxygen | Around 5% O2 for respiring produce, never under 1%; oxygen removed as far as possible for non-respiring foods | Fresh and fresh-cut produce; dried, high-fat and ready-cooked products | Slows respiration in produce; limits oxidation and aerobic growth in everything else |
| Carbon-dioxide-rich | 25–40% CO2 with the balance nitrogen; up to 100% for bakery goods and some cheeses | Raw and cooked meat, fish, ready meals, bakery, cheese | CO2 dissolves into the product and suppresses moulds and Gram-negative spoilage organisms |
| Nitrogen-only | 100% nitrogen | Crisps and snacks, coffee, milk powder | Nitrogen flushing displaces the oxygen that drives rancidity and fills the headspace so the pack holds its shape |
A CO2-heavy pack loses volume and collapses, and nitrogen goes into the mixture as filler to hold the shape.
Low-oxygen and CO2-rich packs come with a distribution condition attached. Non-proteolytic Clostridium botulinum grows from 3.3 °C upward, and US FDA guidance treats refrigeration below that temperature, from packing to consumption, as the controlling barrier where nothing else in the product stops the organism.
Each machine format runs one of the two active methods, and the format sets how low the oxygen can go.
| Machine format | Active method | Pack and typical product | Residual oxygen it can hold |
|---|---|---|---|
| Thermoformer / tray sealer | Compensated vacuum in a sealing chamber, often flush-assisted | Machine-formed or pre-formed tray with lidding film; meat, fish, ready meals | Lowest — under 0.05% is reachable, but only by evacuating below 10 mbar |
| Chamber machine / vacuum pre-made bag machine | Vacuum, then backfill before the final seal | Pre-made bag or doypack; cheese, cured meat, coffee | Low — the air is out before any gas goes in |
| Flow wrapper (HFFS) | Continuous flush only | Pillow pack from a film tube; bakery, produce, confectionery | 2–5%, the level the flushing method reaches |
| VFFS | Continuous flush only | Pillow or gusseted bag from a film tube; crisps, snacks, powders | 2–5%, rising as line speed cuts the flush’s dwell time |
Residual oxygen belongs in the spec only once it has been measured on the line’s own packs.

Get Your Custom Packaging Solution
Tell us about your product and production needs. Our engineers will recommend the right machine configuration for your application.
We only use your details to reply to this request.